Rear

HIGH-PRESSURE FUEL LINES - REAR

REMOVAL

1. Carry out the Pressure Relief - Fuel Tube Venting procedure.







2. Disconnect the rear high-pressure fuel tube.







3. Disconnect the rear high-pressure fuel tube from the midship fuel tank solenoid valve.







4. Remove the P-clip and tube clamp retaining bolts.








5. Remove the rear high-pressure fuel tube.
1 Disconnect the rear high-pressure fuel tube from the forward aft-axle fuel tank solenoid valve.
2 Remove the P-clip retaining bolt.
3 Remove the rear high-pressure fuel tube from the vehicle.

INSTALLATION

1. NOTE:
- Install new fuel tube O-ring seals.
- Lubricate the fuel tube O-ring seals with clean engine oil prior to installation.
- When tightening the fuel tubes, a torque wrench adapter must be used with the torque wrench. The use of a torque wrench adapter will alter the effective torque of the wrench being used. To correct the effective torque, a torque multiplication conversion must be used.

To install, reverse the removal procedure.