Trim Panel - Body Side to Roof Moulding

TRIM PANEL - BODY SIDE TO ROOF MOULDING

REMOVAL

1. NOTE: Step one applies to SuperCab and Crew Cab only.

Remove the rear seat.

2. Remove the rear safety belt retractor and tongue.
3. Remove the rear corner trim panel.







4. Remove the two nuts.
5. Carefully pry the body side-to-roof moulding away from the vehicle body.

INSTALLATION
1. Clean out all remaining sealant from the body side to roof joint and replace with Ford Caulking Cord D6AZ-19560-A or equivalent meeting Ford specification ESB-M4G32-A.
2. Position a new body side-to-roof moulding (painted to match) on the vehicle and press into place.
3. Install the nuts.
4. Install the rear cab corner trim panel, safety belt and rear seat (if applicable).