Rear Window Glass

REAR WINDOW GLASS

REMOVAL

Regular and Crew Cab vehicles
1. Remove the rear trim panels.

SuperCab vehicles
2. Remove the child safety seat tether anchors.
3. Remove the rear corner trim panels.

Vehicles with power sliding window







4. NOTE: Left side is shown, right side is similar.

Remove the left cable swag from the power sliding window.







5. Remove the left transition block from the sliding window trough.







6. Remove the left transition block from the cable end.







7. Pull the left cable end out of the sliding window trough.
8. Repeat steps 4 through 6 for the right side.

All vehicles







9. NOTE:
- Power sliding rear window shown, fixed rear window is similar
- Removal of the rear window glass requires an assistant to hold the rear window glass as it is pushed out.

From inside the vehicle, pull down on the back window glass weatherstrip. Push back the window glass and back window glass weatherstrip from the back window glass opening.







10. Remove the weatherstrip from the rear window.
11. Remove all traces of butyl from the window glass opening, the rear window glass opening and the rear window weatherstrip.

INSTALLATION

All vehicles







1. NOTE: Installation of the rear window requires an assistant to push the rear window glass into the rear window opening from outside the vehicle.

Install the weatherstrip to the rear window.







2. Install the window installation rope on the cab interior side of the rear window weatherstrip ditch. Tie the window installation rope so that it slightly compresses the cab interior side of the rear window weatherstrip.
3. Lubricate the rear window weatherstrip with soapy water.







4. Position the rear window in the rear window opening.
5. Using the assistance of another technician outside the cab, seat the rear window glass and weatherstrip in the rear window opening.
1 Pull the installation rope from the window weatherstrip (technician inside the cab).
2 Push inward and downward on the rear window glass (technician outside the cab).

Vehicles with power sliding window







6. NOTE: Left side is shown, right side is similar.

Install the left cable end into the sliding window trough.







7. Install the left transition block on the cable end.







8. Install the left transition block in the rear sliding window trough.







9. Install the left-hand cable swag into the rear sliding window.

SuperCab vehicles
10. Install the rear corner trim panels.

Regular and Crew Cab vehicles
11. Install the rear trim panel.