Interior Trim Panels

INTERIOR TRIM PANELS

Torx Bit, Safety Belt Bolt:

SPECIAL TOOL(S)

REMOVAL

NOTE: RH side is shown. LH side is similar.

Part 1:

Part 2:

1. Remove the components in the order indicated in the illustration and table.

Items 4, 8, 12: A-Pillar, Upper B-Pillar, C-Pillar Trim Panel Removal Note
1. Position the weatherstrip aside.

Item 6: Cowl Side Trim Panel Removal Note







1. To remove the LH cowl side trim panel, remove the hood release lever.
1 Remove the screw.
2 Remove the hood release lever.







2. Remove the lower cowl trim panel.
1 Remove the pin-type retainer.
2 Remove the lower cowl trim panel.

Item 11: C-Pillar Lower Safety Belt Anchor Bolt Removal Note
1. If equipped with third row seats, position the second row outer seats to the forward position. If not equipped with third row seats, remove the rear seats.

Item 13: D-Pillar Lower Safety Belt Anchor Bolt Removal Note







1. If equipped with third-row seating, release the two levers located at each lower outboard edge of the third row seat cushion to access the D-pillar lower safety belt anchor bolt.

Item 14: D-Pillar Trim Panel Removal Note
1. Position the weatherstrip aside.







2. Remove the upper headliner trim panel.

Item 16: Rear Quarter Trim Panel Removal Note
1. If equipped with third-row seating, remove the third-row seat.







2. If equipped, remove the luggage assembly cover.







3. Remove the stowage compartment doors.







4. NOTE: Right side shown, left side similar.

Remove the stowage compartment assembly.







5. Position the carpet aside.







6. Remove the brackets.
- Remove the bolts.

INSTALLATION
1. Install in the reverse order of removal.

Item 12: C-Pillar Trim Panel Installation Note
1. Be sure the hole on the back of the trim panel is seated over the upper safety belt anchor bolt.

Item 8: Upper B-Pillar Trim Panel Installation Note
1. Be sure the hole on the back of the trim panel is seated over the upper safety belt anchor bolt.