Solenoid Body Assembly

Solenoid Body Assembly





Material

1. With the vehicle in PARK, position on a hoist.
2. Remove the components in the order indicated in the above illustration and table.

Part 1 Of 2:

Part 2 Of 2:

3. To install, reverse the removal procedure.
4. Carry out a fluid level check.
5. Verify that the shift cable is adjusted correctly.





Item 11: Solenoid Body O-Ring Seals Installation Note
1. Install new O-ring seals on the solenoid body connector. Lubricate the O-ring seals with clean automatic transmission fluid.





Item 8 and 9: Solenoid Body Screws Installation Note

1. CAUTION: Inspect the transmission case bore to make sure it is free of foreign material and not damaged. If damaged, a transmission leak may occur.

Install the solenoid body. Tighten the screws in the sequence shown.





Item 4: Transmission Fluid Pan Installation Note
1. Install the transmission fluid pan and gasket and loosely install the screws.





Item 3: Transmission Fluid Pan Screws Installation Note
1. Tighten the screws in a crisscross sequence.





Item 2: Solenoid Body Harness Electrical Connector Installation Note

1. CAUTION: Damage will occur to the solenoid body assembly if the screw is tightened above the specification.

NOTE: Always install new O-ring seals on the vehicle harness connector.

NOTE: Clean the area around the connector to prevent contamination of the solenoid body connector.

NOTE: Use petroleum jelly to lubricate the O-ring seals to aid in the installation process.

Install and lubricate new O-ring seals on the transmission connector and connect the connector.