Sensor, Front

Front Wheel Speed Sensor and Sensor Ring - 4WD

Removal and Installation

NOTE: Right side shown, left side similar.

1. Remove the front wheel and tire assembly.








2. Remove the parts in the order indicated in the following illustration and table.
3. To install, reverse the removal procedure.

Item 1: Harness Connector Removal Note

1. NOTE: The harness connector is located in the engine compartment secured to the fender apron.

Item 2: Harness Retainers Removal Note
1. Unclip the front wheel speed sensor harness retainer from the brake line.

Item 4: Front Disc Brake Caliper Assembly Removal Note

1. CAUTION: When removing the front disc brake components, never allow them to hang from the brake hose.

Support the front brake caliper to the vehicle.

Item 5: Front Rotor Removal Note
1. Match mark the front disc and front wheel hub flange before removing the front rotor.

Item 8: Sensor Ring Removal Note
1. The sensor ring is integral to the front wheel hub and bearing assembly.