Transmission Position Sensor/Switch: Service and Repair
Digital Transmission Range (TR) Sensor-4x4Special Tools And Equipment:
Special Tool(s)
Removal and Installation
CAUTION: Do not pry on the swivel tube to disconnect the transmission shift linkage.
CAUTION: Discard outer manual control lever shaft nut. Do not reuse. The old nut will not retain torque specification.
NOTE: Manual shift lever must be in the NEUTRAL position.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: The front driveshaft does not need to be removed from the vehicle. Position the front driveshaft out of the way.
Remove the parts in the order listed in the illustration and table.
3. To install, reverse the removal procedure.
Item 4: Front Driveshaft Removal Note
1. Index-mark the front flange.
2. Index-mark the rear flange at the transfer case.
Item 10: Digital TR Sensor Installation Note
1. Install the digital TR sensor and loosely install the bolts.
2. NOTE: The manual lever must be in the NEUTRAL position.
Using the special tool, align the digital TR sensor slots. The tool is designed to fit snug.
3. CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.
Tighten the bolts.
Item 4: Front Driveshaft Installation Note
1. Align the index mark on the front flange.
2. Align the index mark on the rear flange at the transfer case.