150000 MI or 240000 KM
LubricateWheel Bearing
Lubricate 4x2 wheel bearings or 4x4 hub needle bearings (under trailer towing or off-road conditions, as required). Install new wheel bearing grease seals (under commercial use, as required)
Control Arm
If using Special Operating Conditions I. Refer to Special Operating Conditions (Read This First). Lube front lower control arm and steering linkage ball joints with zerk fittings, if equipped.
Inspect
Wheels
Inspect wheels for end play and noise.
Vehicle
Perform Multi-Point Inspection (Recommended by Ford) Refer to Routine Service.
Universal Joint, Drive/Propeller Shaft
If equipped, inspect and lubricate 4x4 front axle shaft U-joints
Steering and Suspension
Inspect steering linkage and suspension. Inspect steering linkage, suspension and, if equipped, driveshaft and ball joints. If equipped, inspect and lubricate 4x2 ball joints and steering idler arms.
Heat Shield, Exhaust
Exhaust System
Inspect exhaust system and heat shields.
Drive/Propeller Shaft
If equipped.
Cooling System
Inspect cooling system and hoses.
Brakes and Traction Control
Inspect brake pads,shoes, brake discs, drums, brake lines and hoses.
Ball Joint
Replace
Oil Filter, Engine
Replace oil filter only if NOT using Special Operating Conditions T, I or D. Replace oil filter under all operating conditions.
Fuel Filter
Replace fuel filter. All Operating Conditions.
Fluid Filter - A/T
All Operating Conditions
Fluid Filter - A/T
If equipped, change the external transmission fluid filter and in-line service installed transmission fuild filter.
Fluid - Differential
Replace differential fluid (front and/or rear where applicable)
Fluid - A/T
Operating Conditions I, D and O only.
Fluid - A/T
All Operating Conditions
Fluid - A/T
Engine Oil
Replace engine oil for all Special Operating Conditions. Replace oil only if NOT using Special Operating Conditions T, I or D.
Air Filter Element
Rotate
Tires
Inspect tires for wear.