Removal and Installation
FUEL CONDITIONING MODULEFuel Line Disconnect Tool:
Special Tool(s)
Removal and Installation
1. WARNING: Smoking and open flame of any type must not be present when working near fuel or fuel vapor. Failure to follow these instructions may result in personal injury.
With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect both battery ground cables.
3. Open the fuel/water separator drain valve to release the fuel pressure.
4. Disconnect the fuel conditioning module electrical connectors.
5. NOTE: Rear fuel hoses shown, front fuel hoses similar.
Remove the fuel hoses retaining clips. Using the special tool, disconnect the four fuel hoses.
6. Disconnect the wiring push pin. Remove the mounting bolts and the fuel conditioning module.
7. To install, reverse the removal procedure.