Differential Seals - RH

Differential Seals-RH





Special Tool(s)





Material

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.





2. Remove the transaxle drain plug and drain the transmission fluid.
3. Remove the RH halfshaft.
4. If equipped, remove the Power Takeoff (PTO).





5. If the vehicle is equipped with a PTO, use the special tools to remove the RH differential seal.





6. If the vehicle is not equipped with a PTO, use the special tools to remove the RH differential seal.

Installation





1. If the vehicle is equipped with a PTO, use the special tools to install the RH differential seal.





2. If the vehicle is not equipped with a PTO, use the special tools to install the RH differential seal.
3. If equipped, install the PTO.
4. Install the RH halfshaft.





5. Using a small amount of pipe sealant on the threads, install the transaxle drain plug.
^ Tighten to 27 Nm (20 ft. lbs.).
6. Fill the transaxle with clean automatic transmission fluid.
7. Start the engine and run through all the gears and check fluid level.