Ignition Switch: Service and Repair

Ignition Switch

Removal and Installation
1. Remove the steering wheel.





2. NOTE: Lower tilt release handle to access second screw.

Remove the lower steering column shroud.
^ Remove the screws.





3. NOTE: The screw is located behind the multifunction switch.

Remove the screw and the upper steering column shroud.





4. Remove the bolt, push the release and position the multifunction switch aside.





5. Disconnect the ignition switch electrical connector.





6. Remove the ignition switch.
7. To install, reverse the removal procedure.
^ Make sure that the spring located under the ignition switch is positioned on the steering column lock rod.