Vehicle Security Module

VEHICLE SECURITY MODULE

Worldwide Diagnostic System (WDS):

Special Tool(s)







Removal and Installation

CAUTION: Prior to removal of the vehicle security module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed.

1. Remove the RH rear quarter trim panel.
2. Disconnect the 3 vehicle security module electrical connectors.
3. Remove the 3 vehicle security module screws.
4. Remove the vehicle security module.

5. NOTE: Once the module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module.

To install, reverse the removal procedure.