Ignition Coil: Service and Repair

IGNITION COIL







Exploded View

Removal and Installation
1. Disconnect the battery ground cable.
2. Disconnect the ignition coil electrical connector.
3. Disconnect the radio noise suppressor electrical connector.

4. CAUTION: It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.

NOTE: Spark plug wires must be connected to the correct ignition coil terminal. Mark the spark plug wires for installation reference.

Squeeze the tabs and twist while pulling upward to disconnect the 6 spark plug wires.

5. Remove the 4 bolts and the ignition coil.
- To install, tighten to 6 Nm (53 lb-in).

6. NOTE: Apply silicone dielectric compound to the inside of the ignition coil boots.

To install, reverse the removal procedure.