Alternator: Service and Repair

GENERATOR

Part 1:

Part 2:

Removal and Installation
1. Disconnect the battery.
2. Remove the nuts and the engine cover assembly.
- To install, tighten to 6 Nm (53 lb-in).

3. Rotate the front end accessory drive belt tensioner clockwise and position the front end accessory drive belt aside.
4. Position the protective cover aside and remove the generator B+ terminal nut.
- To install, tighten to 8 Nm (71 lb-in).

5. Disconnect the generator B+ terminal and the electrical connector. 6. Remove the 4 bolts and the generator bracket.
- To install, tighten to 10 Nm (89 lb-in).

7. Loosen the 2 bolts and remove the generator.
- To install, tighten to 25 Nm (18 lb-ft).

8. If necessary, remove the nut and the generator pulley.
- To install, tighten to 109 Nm (80 lb-ft).

9. To install, reverse the removal procedure.