Operation CHARM: Car repair manuals for everyone.

Harmonic Balancer - Crankshaft Pulley

Vibration damper face runout (max) 0.635 mm (0.025 in)
Vibration damper rubber bulging (max) 1.5 min (0.059 in)





Crankshaft pulley (6.0L) (dual alternator) 47 Nm (35 ft. lbs.)





CAUTION: To prevent engine damage, you must always install four new bolts when installing the vibration damper.

NOTE: Do not use anti-seize compounds, grease, or any lubricants. Lubricants have an adverse effect on the torque results.

Install the crankshaft vibration damper and bolts.
Tighten the bolts in the sequence shown.
Tighten the bolts to 68 Nm (50 ft. lbs.).
Tighten the bolts an additional 90 degrees.