Cruise Control Servo: Service and Repair

SPEED CONTROL ACTUATOR







Removal
1. Remove the air cleaner assembly.
2. Disconnect the speed control actuator cable from the throttle body.
3. Disconnect the speed control actuator electrical connector.







4. Disconnect the speed control cable from the speed control actuator.
1 Press the locking tab.
2 Rotate the speed control cable cap counterclockwise.

5. Remove the 2 speed control actuator bolts and the speed control actuator.

Installation
1. Install the speed control actuator and the 2 bolts.
- Tighten the bolts to 10 Nm (89 lb-in).







2. NOTE: Incorrect wrapping of the speed control cable core wire around the speed control actuator pulley may result in a high idle condition.

Insert the speed control cable slug into the speed control actuator pulley slot.
1 Gently push the retaining spring.
2 Insert the speed control cable slug completely into the speed control actuator pulley slot.







3. NOTE: Make sure the rubber seal is correctly seated onto the speed control cable cap.

Align the speed control cable cap tabs with the slots in the speed control actuator housing and seat the speed control cable cap.







4. Rotate the speed control cable cap clockwise until the locking tab engages.
5. Connect the speed control actuator electrical connector.
6. Connect the speed control actuator cable to the throttle body.
7. Install the air cleaner assembly.