Ignition Coil: Service and Repair

"AllData Editors Note:

Customers have reported success using the following spark plug wire placement on the coil pack."






IGNITION COIL







Exploded View

Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the wiper motor and pivot assembly.
3. Disconnect the electrical connector from the ignition coil.

4. CAUTION:
- It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wires.
- Spark plug wires must be connected to the correct ignition coil terminal. Mark the spark plug wire locations before removing them.

Disconnect the 6 spark plug wires from the ignition coil.

5. Remove the 3 bolts and the ignition coil.
- To install, tighten to 7 Nm (62 lb-in).

6. To install, reverse the removal procedure.