Ignition Coil: Service and Repair

IGNITION COIL-ON-PLUG







Exploded View


Removal and Installation

RH ignition coils
1. Remove the upper intake manifold.

All ignition coils
2. Disconnect the ignition coil electrical connectors.
3. Remove the ignition coil bolts.
- To install, tighten to 6 Nm (53 lb-in).

4. NOTE: When removing the ignition coils, a slight twisting motion will break the seal and ease removal.

Remove the ignition coils.

5. To install, reverse the removal procedure.
- Apply a light film of Silicone Brake Caliper Grease and Dielectric compound XG-3-A or equivalent meeting Ford specifications ESE-M1C171-A to the inside of the coil boots before installation.