Removal and Installation
FRONT SEAT CUSHION - BUCKET AND 40 PERCENTRemoval
WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
- If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental restraint system (SRS) must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Driver seat is shown, passenger seat is similar.
1. Depower the SRS.
2. Remove the affected seat.
3. Remove the affected seat backrest.
4. Remove the four bolts and remove the seat cushion assembly.
Installation
1. Install the seat cushion assembly and install the four bolts.
2. Install the affected seat backrest.
3. Install the affected seat.
4. Repower the SRS.