Front Door Window Regulator: Service and Repair

MOTOR AND WINDOW REGULATOR

Heavy Duty Riveter:

Special Tool(s)

Removal and Installation
1. Remove the door trim panel.







2. Remove the watershield.







3. Support the window glass.







4. If equipped, disconnect the power window motor electrical connector.







5. Loosen the center door glass run retainer.
- Remove the top and bottom center door glass run retainer nuts.







6. NOTE:
- To remove the rivets, use a drift punch to remove the steel centers and a 6.35 mm (1/4 in) diameter drill bit to remove the rivets.
- The power window regulator has four rivets; the manual has three.

Remove the window regulator rivets.
1 Remove the steel centers.
2 Remove the rivets.







7. Remove the window regulator.







8. WARNING: Prior to the power window motor removal, ensure the regulator arms are in a fixed position to prevent counterbalance spring unwind. Failure to place the regulator arms in a fixed position can cause the spring to suddenly release resulting in personal injury.

If necessary, remove the window glass motor.
1 Remove the bolts.
2 Remove the motor.












9. To install, reverse the removal procedure.
- Use Heavy Duty Riveter to install the new rivets.