Extension Housing Gasket - 4X4

Extension Housing Gasket - 4x4





Material

Removal
1. Remove the transfer case.
2. Remove the wire harness locators from the extension housing wire bracket.





3. Remove the transmission mount nuts.





4. Raise and support the transmission.





5. Remove the six extension housing screws and studs.





6. NOTE: The parking pawl, parking pawl return spring and parking pawl shaft may fall out during removal of the extension housing.

Remove the extension housing. Discard the extension housing gasket.

Installation





1. Clean the extension housing and install a new extension housing gasket. Make sure that the parking pawl, spring and shaft are correctly installed.





2. CAUTION: Make sure the parking lever actuating rod is correctly seated in the case parking rod guide cup.

Install the extension housing.
^ Position the extension housing and install the six extension housing screws and studs.





3. Install the transmission mount into the crossmember and tighten the nuts.
4. Install the wire harness locators from the extension housing wire bracket.
5. Install the transfer case.
6. Fill the transmission with clean automatic transmission fluid to the correct level and check for correct transmission operation.