Oil Pressure Sender: Service and Repair
Oil Pressure SenderMaterial:
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 5 bolts and the RH splash shield.
^ To install, tighten to 9 Nm (80 inch lbs.).
3. Disconnect the oil pressure sender electrical connector.
4. Remove the oil pressure sender.
^ To install, tighten to 15 Nm (11 ft. lbs.).
5. To install, reverse the removal procedure. Apply pipe sealant with Teflon to the oil pressure sender threads.