Transaxle Rear Support Insulator

Transaxle Rear Support Insulator





Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the transaxle rear support insulator bolt.
^ To install, tighten to 80 Nm (59 ft. lbs.).
3. Remove the 2 transaxle rear support insulator nuts.
^ To install, tighten to 80 Nm (59 ft. lbs.).
4. Remove the transaxle rear support insulator through-bolt and washer.
^ To install, tighten to 115 Nm (85 ft. lbs.).
5. Remove the transaxle rear support insulator.
6. If necessary, remove the 3 bolts and the transaxle rear support insulator bracket.
^ To install, tighten to 48 Nm (35 ft. lbs.).
7. To install, reverse the removal procedure.