Driveshaft Indexing
Driveshaft IndexingNOTE: If indexing the driveshaft does not eliminate the vibration, balance the driveshaft. Refer to Driveshaft Runout and Balancing.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. CAUTION: Do not reuse the CV joint bolts and washers. Install new bolts and washers or damage to the vehicle may occur.
Remove and discard the 6 front driveshaft-to-transfer case bolts and washers.
3. Rotate the flange 60 degrees.
4. Connect the front driveshaft and install the 6 new bolts and washers.
^ Tighten to 37 Nm (27 ft. lbs.).
5. CAUTION: Do not reuse the bolts and cap straps for the pinion yoke. Install new bolts and cap straps or damage to the vehicle may occur.
Disconnect the rear driveshaft universal joint.
^ Discard the 4 bolts and the 2 cap straps.
6. Rotate the rear pinion 180 degrees.
7. Connect the rear driveshaft and install 4 new bolts and 2 new cap straps.
^ Tighten to 23 Nm (17 ft. lbs.).
8. Lower the vehicle and test drive.
9. Repeat the procedure if necessary.