Halfshaft Seal RH
Halfshaft Seal RHSpecial Tool(s):
Removal
NOTE: If the transfer case is leaking automatic transaxle fluid, install a new transfer case driven gear seal.
1. Remove the exhaust system crossover pipe.
2. Remove the 3 bolts and the transfer case heat shield.
3. Remove the front drive axle intermediate shaft.
4. Remove the transfer case RH halfshaft dust shield.
5. Remove the transfer case RH halfshaft oil seal.
Installation
1. NOTE: Press the transfer case RH halfshaft seal until it is flush with the transfer case cover.
Using the special tools, install the RH halfshaft seal.
2. NOTE: Press the transfer case RH halfshaft dust shield firmly to snap it into position.
Install the transfer case RH halfshaft dust shield.
3. NOTE: Clean the intermediate shaft before assembly. Use 600 grit sandpaper on the seal journals and wipe them dry.
Install the front drive axle intermediate shaft.
4. Install the transfer case heat shield and the 3 transfer case heat shield bolts.
^ Tighten to 14 Nm (10 ft. lbs.).
5. Install the exhaust system crossover pipe.
6. Check the transfer case fluid level.
7. Check the transaxle fluid level.