Battery Cable: Service and Repair

BATTERY CABLES

LH Engine Connections:

RH Engine Connections:

Removal and Installation
1. Disconnect the battery.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Remove the nut and position the battery cable body ground terminal aside.
- To install, tighten to 9 Nm (80 lb-in).

4. Disconnect the battery cable electrical connector.
5. Remove the 2 battery cable locators from the battery tray.
6. Remove the BJB terminal nuts.
- To install, tighten to 9 Nm (80 lb-in).

7. Position the generator harness terminal aside.
8. Position the BJB terminal aside.
9. Remove the 2 nuts and position the battery cable bracket aside.
- To install, tighten to 20 Nm (15 lb-ft).

10. Remove the nut and position the power steering (P/S) line bracket aside.
- To install, tighten to 12 Nm (9 lb-ft).

11. Remove the nut and position the battery cable engine front cover bracket aside.
- To install, tighten to 9 Nm (80 lb-in).

12. Disconnect the A/C compressor electrical connector.
13. Remove the A/C compressor electrical connector locator.
14. Remove the bolt and position the battery cable right engine mount bracket aside.
- To install, tighten to 25 Nm (18 lb-ft).

15. Remove the starter solenoid terminals protective cap.
16. Remove the nut and position the starter solenoid positive cable terminal aside.
- To install, tighten to 13 Nm (10 lb-ft).

17. Remove the nut and position the starter solenoid wire cable terminal aside.
- To install, tighten to 6 Nm (53 lb-in).

18. Remove the nut and position the battery cable engine ground terminal aside.
- To install, tighten to 15 Nm (11 lb-ft).

19. Remove the battery cable.
20. To install, reverse the removal procedure.