Oil Pan: Service and Repair
Oil PanMaterial:
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the front axle, if equipped.
3. Remove the stabilizer bar.
4. Remove the drain plug and drain the engine oil Install the drain plug when finished.
^ Tighten to 26 Nm (19 ft. lbs.).
5. Remove the nut and position the power steering pressure (PSP) hose bracket aside.
6. Remove the nut and position the battery cable bracket aside.
7. Disconnect the oil temperature sensor electrical connector.
8. Detach the wiring harness retainers from the RH side oil pan bolts.
9. Remove the bolts and the oil drain splash shield.
10. If equipped with a block heater, detach the block heater wiring harness retainer from the LH side oil pan bolt.
11. Remove the bolts, the oil pan and the gasket.
^ Discard the gasket.
Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These may cause scratches and gouges resulting in leak paths. Use a plastic scraper to clean the sealing surfaces. Failure to follow these directions can cause future oil leaks.
Clean and inspect the sealing surfaces with silicone gasket remover, metal surface prep, and a plastic scraper. Follow the directions on the packaging.
2. NOTE: If the oil pan and gasket are not secured within 4 minutes of sealer application, the sealant must be removed and the sealing surfaces cleaned with silicone gasket remover and metal surface prep. Follow the directions on the packaging.
Apply silicone gasket and sealant in 2 places as shown.
3. NOTE: If the oil pan and gasket are not secured within 4 minutes of sealer application, the sealant must be removed and the sealing surfaces cleaned with silicone gasket remover and metal surface prep. Follow the directions on the packaging.
Apply silicone gasket and sealant in 2 places as shown.
4. Position a new oil pan gasket and the oil pan and install the bolts finger tight.
5. Tighten the bolt in 3 stages in the sequence shown.
^ Stage 1: Tighten to 2 Nm (18 inch lbs.).
^ Stage 2: Tighten to 20 Nm (15 ft. lbs.).
^ Stage 3: Tighten an additional 60 degrees.
6. If equipped with a block heater, attach the block heater wiring harness retainer to the LH oil pan bolt.
7. Position the oil drain splash shield and install the bolts.
^ Tighten to 12 Nm (9 ft. lbs.).
8. Attach the wiring harness retainers to the RH oil pan bolts.
9. Connect the oil temperature sensor electrical connector.
10. Attach the battery cable bracket and install the nut.
^ Tighten to 10 Nm (89 inch lbs.).
11. Attach the PSP hose bracket and install the nut.
^ Tighten to 10 Nm (89 inch lbs.).
12. Install the stabilizer bar.
13. Install the front axle, if equipped.
14. Fill the engine with clean engine oil.