Safety Belt Buckle - Second Row, Bucket

SAFETY BELT BUCKLE - SECOND ROW, BUCKET







Removal and Installation

WARNING: All safety belt assemblies (including retractors, belt tension sensors [BTS] if equipped, buckles, shoulder belt height adjusters [if equipped], child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these instructions could increase the risk of injury in collisions.

1. Tilt the second row seat forward.
2. Remove the bolt and safety belt buckle.
- To install, tighten to 47 Nm (35 lb-ft).

3. NOTE: Sealant must be applied to the safety belt buckle bolt when installed.

To install, reverse the removal procedure.

4. Check the active restraint system for correct operation.