Wheel Speed Sensor - Rear

Wheel Speed Sensor - Rear

Wheel Speed Sensor - Rear:

Removal and Installation

CAUTION: Clean off dirt and foreign material that may have collected around the rear axle speed sensor before removal to prevent fluid contamination.

1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. Disconnect the rear axle speed sensor electrical connector.

4. NOTE: Do not apply force to the plastic rear axle speed sensor connector.

Remove the bolt and the rear axle speed sensor.
^ To install, tighten to 20 Nm (15 ft. lbs.).
5. To install, reverse the removal procedure.