Gear Sensor/Switch: Service and Repair

Gearmotor Encoder Assembly

Material:

Material

Removal and Installation
1. Set the mode select switch to the 4WD HIGH position.
2. With the vehicle in NEUTRAL, position it on a hoist.





3. Disconnect the gearmotor encoder assembly harness connectors.





4. Remove the 3 gearmotor encoder bolts and the gearmotor encoder assembly.
^ To install, tighten to 20 Nm (15 ft. lbs.).

5. Remove the grease from the motor adapter and check for any nicks or burrs. If any damage is found, repair or install a new adapter as necessary.
6. To install, reverse the removal procedure.
^ Apply a coat of grease to the new motor adapter.