Engine Control Module: Service and Repair

POWERTRAIN CONTROL MODULE (PCM)







Removal and Installation
1. Disconnect the battery ground cable.







2. Remove the instrument panel side trim.







3. Remove the cowl side trim panel.







4. Remove the glove compartment.







5. Remove the passenger side lower footwell trim panel.
6. Remove the 2 generic electronic module (GEM) nuts and position aside.
- To install, tighten to 10 Nm (89 lb-in).

7. Disconnect the powertrain control (PCM) module electrical connectors and remove the PCM.

8. CAUTION: Make sure that the PCM electrical connectors do not unlock when installing the GEM module.

To install, reverse the removal procedure.