C-Pillar Trim Panel - SuperCab Two-Door

C-PILLAR TRIM PANEL - SUPERCAB TWO-DOOR

Special Tool(s):

Special Tool(s)

Removal and Installation

All vehicles
1. Remove the door scuff plate trim panel.
1 Remove the screws.
2 Remove the scuff plate.

2. Remove the A-pillar trim panel.
3. Remove the cab rear trim panel.







4. NOTE:
- If the safety belt guide cover is damaged or if it does not remain closed, install a new cover.
- Safety belt cover removed for clarity.

From behind the front belt guide cover, release the retaining tab and open the cover.







5. Remove the nut and safety belt guide.
- To install, tighten to 40 Nm (30 lb-ft).







6. Remove the safety belt anchor bolt.
- To install, tighten to 40 Nm (30 lb-ft).

Without center-facing rear seat







7. Remove the C-pillar trim panel floor screws.







8. Open the storage compartment.

With center-facing rear seat







9. Remove the pin-type retainers and lower rear trim panel.







10. Remove the C-pillar trim panel floor screws.







11. Open the rear seat.


All vehicles






12. Remove the C-pillar trim panel pin-type retainers.
13. Disconnect the radio speaker electrical connector.
14. Remove the C-pillar trim panel.
- Feed the safety belt webbing through the quarter trim panel.

15. To install, reverse the removal procedure.