Seat Track - 60 Percent Bench
SEAT TRACK - 60 PERCENT BENCHRemoval
WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the SRS.
2. Remove the affected seat.
3. Remove the 60 percent bench armrest.
4. Remove the 60 percent seat backrest assembly.
5. Remove the seat track spring.
6. Remove the seat track adjustment lever.
- Remove one side of the seat track adjustment lever at a time.
7. Remove the 2 rear seat cushion-to-frame bolts.
8. Remove the 2 front seat cushion-to-frame bolts and remove the seat track from the seat cushion frame.
9. Remove the 8 seat track-to-seat cushion frame nuts and separate the seat track from the seat cushion frame.
Installation
1. Install the seat track-to-seat cushion frame and install the 8 nuts.
- Tighten to 25 Nm (18 lb-ft).
2. Install the 2 front seat cushion-to-frame bolts.
- Tighten to 11 Nm (8 lb-ft).
3. Install the 2 rear seat cushion-to-frame bolts.
- Tighten to 11 Nm (8 lb-ft).
4. Install the seat track adjustment lever.
- Install one side of the seat track adjustment lever at a time.
5. Install the seat track spring.
6. Install the 60 percent seat backrest assembly.
7. Install the 60 percent bench armrest.
8. Install the affected seat.
9. Repower the SRS.