Front Seat Backrest - 60 Percent Bench
FRONT SEAT BACKREST - 60 PERCENT BENCHRemoval
All seats
WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the SRS.
2. Remove the 60 percent bench seat.
3. Remove the 60 percent bench armrest.
4. Remove the seat back adjusting handle screw and the handle.
5. Remove the screw on the side shield.
6. Remove the front side shield screw.
7. Pull out on the side and the rear of the side shield to detach the 2 clips (1 shown).
8. Remove the outboard recliner cable anchor and swivel the recliner cable end and remove.
9. Remove the outboard pin-type retainer and position the material aside.
10. Remove the 2 outboard backrest recliner bolts.
11. Remove the inboard seat back latch release cable anchor and swivel the cable end and remove.
12. Remove the front inboard backrest latch bolt.
SuperCab seat
13. Remove the inboard rear bolt cover.
All seats
14. Remove the inboard rear backrest latch bolt.
15. Remove the backrest assembly.
Installation
All seats
1. Install the backrest assembly.
2. Install the inboard rear backrest latch bolt.
- Tighten to 25 Nm (18 lb-ft).
SuperCab seat
3. Install the inboard rear bolt cover.
All seats
4. Install the inboard front backrest latch bolt.
- Tighten to 25 Nm (18 lb-ft).
5. Install the inboard seat back latch release cable end and swivel and install the cable anchor.
6. Install the 2 outboard backrest latch bolts.
- Tighten to 25 Nm (18 lb-ft).
7. Position the material and install the outboard pin-type retainer.
8. Install the outboard seat back latch release cable end and swivel and install the cable anchor.
9. Position the side shield and install the 2 clips (1 shown).
10. Install the front side shield screw.
11. Install the screw on the side shield.
12. Install the recliner handle and install the screw.
13. Install the 60 percent bench armrest.
14. Install the 60 percent bench seat.
15. Repower the SRS.