Fuel Supply Line: Service and Repair

FUEL LINES

Part 1:

Part 2:

Exploded View

Removal and Installation
1. Remove the fuel tank.







2. If equipped, remove the fuel tube heat shield.
- To install, tighten to 22 Nm (16 lb-ft).

3. Disconnect the rear fuel tank vapor tube and fuel tank pressure sensor assembly-to-evaporative emissions (EVAP) canister quick connect coupling.
4. Disconnect the fuel supply tube-to-fuel rail supply tube spring lock coupling.
5. Disconnect the front fuel tank vapor tube-to-EVAP purge solenoid vapor tube quick connect coupling.
6. Disconnect the fuel tubes-to-fuel filter quick connect couplings.
7. Disconnect the fuel supply tubes and fuel vapor tubes from the frame clips and remove.
8. To install, reverse the removal procedure.