Engine Control Module: Service and Repair

POWERTRAIN CONTROL MODULE (PCM)







Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the powertrain control module (PCM) wiring harness retainer nut.
- To install, tighten to 10 Nm (89 lb-in).

3. Loosen the bolt and disconnect the PCM electrical connector.
- To install, tighten to 7 Nm (62 lb-in).

4. Remove the stud bolt and position aside the ground cable and PCM wiring harness.
- To install, tighten to 10 Nm (89 lb-in).

5. Remove the 2 nuts and the PCM cover.
- To install, tighten to 7 Nm (62 lb-in).

6. Remove the PCM.
7. To install, reverse the removal procedure.