Wheel Speed Sensor - Front
Wheel Speed Sensor - Front, 4X4Material:
Removal and Installation
1. Remove the brake disc shield.
2. Disconnect the battery ground cable. For additional information, refer to Battery.
3. Disconnect the wheel speed sensor electrical connector.
4. Remove the wheel speed sensor harness bolt and unclip the retainers.
^ To install, tighten to 8 Nm (71 inch lbs.).
5. Remove the wheel speed sensor bolt and the wheel speed sensor.
^ To install, tighten to 12 Nm (9 ft. lbs.).
6. NOTE: Plug the sensor cavity and thoroughly clean the sensor mounting surface. Apply wheel bearing grease to the mounting surface.
To install, reverse the removal procedure.