Seat Temperature Switch: Service and Repair

SEAT CONTROL SWITCH

Removal and Installation

WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Depower the supplemental restraint system (SRS).







2. Remove the screw from behind the manual backrest adjust handle.







3. Remove the cushion side shield front screw.







4. Remove the cushion side shield rear screw from under the cushion side shield.







5. Disconnect the seat control switch electrical connector from under the front of the cushion frame.







6. Remove the seat control switch.
1. Pull the cushion side shield away from the cushion.
2. Pull the seat control switch electrical connector through the seat cushion.
3. Remove the screws.
4. Remove the seat control switch.

7. To install, reverse the removal procedure.
8. Repower the SRS.