Roof Opening Panel Trim - Fixed Glass, Interior

ROOF OPENING PANEL - EXPLODED VIEW

Exterior Trim, Seals, Fixed Glass And End Caps:

Air Deflector Assembly:

Sliding Glass, Blinds And Primary Seal:

Idler Track And Mechanism:

Front And Rear Sunshade Assembly:

Rear Trim Ring Assembly:

Roof Opening Panel Motor(s) And Electrical:

Motor Block And Drive Tube Assembly:

Guide Tracks And Mechanisms:

Front Guide Track Mechanism:

ROOF OPENING PANEL TRIM - FIXED GLASS, INTERIOR

Removal and Installation
1. Position the sunshade(s) to the fully OPEN position.
2. Carefully bend/pry the trim ring from its hook-and-loop tape pads.

3. NOTE: A piece of paper may assist in keeping the hook-and-loop tape from sticking while aligning the trim ring. Once the trim ring is in position (front and rear locating pins lined up), remove the paper and press the trim firmly in place.

To install, reverse the removal procedure.