Roof Opening Panel Glass - Front Sliding
ROOF OPENING PANEL - EXPLODED VIEWExterior Trim, Seals, Fixed Glass And End Caps:
Air Deflector Assembly:
Sliding Glass, Blinds And Primary Seal:
Idler Track And Mechanism:
Front And Rear Sunshade Assembly:
Rear Trim Ring Assembly:
Roof Opening Panel Motor(s) And Electrical:
Motor Block And Drive Tube Assembly:
Guide Tracks And Mechanisms:
Front Guide Track Mechanism:
ROOF OPENING PANEL GLASS - FRONT SLIDING
Removal and Installation
1. Open the roof opening panel to the VENT position.
2. Detach the top of the concertina blind from the moving glass frame.
3. Reposition the sliding glass panel to any position rearward of VENT position.
4. Remove the 4 roof opening panel glass front screws.
- To install, tighten to 8 Nm (71 lb-in).
5. Remove the 2 roof opening panel glass rear screws.
- To install, tighten to 8 Nm (71 lb-in).
6. CAUTION: It is possible for the idler mechanism to move freely once the glass panel is removed. Do not move the idler rearward or it may disengage from the idler track.
Carefully remove the roof opening panel glass.
7. To install, reverse the removal procedure.
- Initialize the roof opening panel motor(s).