Operation CHARM: Car repair manuals for everyone.

Seat Control Switch-Front



Seat Control Switch - Front

Special Tool(s):






Removal and Installation

Warning: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.

NOTE: The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

ALL SEATS

1. If possible, position the seat all the way up and center the seat in the front door opening.

2. Depower the supplemental restraint system (SRS). Refer to Service and Repair

3. Separate the safety belt retractor belt anchor from the seat in the following sequence.

1. Carefully pull up and out to remove the safety belt retractor belt anchor nut cover from the cushion side shield.
2. Remove the safety belt anchor nut. To install, tighten to 47 Nm (35 lb-ft).
3. Separate the safety belt retractor belt anchor from the seat.

4. Remove the seat control switch in the following sequence.

1. Pull out and remove the seat control switch knob(s).
2. If equipped with manual recline, release the clip and remove the manual recline handle.
3. If equipped with manual lumbar, pull and remove the manual lumbar handle.
4. Remove the cushion side shield screw(s).
5. Slide the cushion side shield up in the rear to release the retailer.
6. Slide the cushion side shield forward to disengage the retainer.
7. Release the cushion side shield clips and separate the seat control switch.
8. Disconnect the seat control switch electrical connector and remove the switch.

5. To install, reverse the removal procedure.

6. Repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time. Refer to Service and Repair

PASSENGER SEAT

7. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS. Refer to Seat Occupant Classification Module - Air Bag