Instrument Cluster (IC)
INSTRUMENT CLUSTEREdge:
MKX:
Removal
All vehicles
NOTE: When installing a new instrument cluster, it is necessary to upload the module configuration to the scan tool.
1. Disconnect the battery.
2. Remove the 2 screws and the lower steering column cover.
- If equipped, disconnect the ambient air temperature sensor air hose and electrical connector.
3. Tilt the steering column to the lowest position.
Edge
4. NOTE: The instrument panel center finish panel is held in place by spring clips located on the finish panel.
Pull the instrument panel center finish panel straight out to release the retaining tabs and position aside.
All vehicles
5. Release the 4 locating tabs on the instrument cluster finish panel gap hiding reveal from the upper steering column cover.
6. NOTE: The upper section of the instrument cluster finish panel is held in place by spring clips located on the finish panel.
Remove the 2 screws and the instrument cluster finish panel.
- If equipped, disconnect the power liftgate switch electrical connector.
7. Remove the 4 screws and the instrument cluster.
- Disconnect the electrical connector.
Installation
All vehicles
1. Position the instrument cluster, connect the electrical connector and install the 4 screws.
2. NOTE: The upper section of the instrument cluster finish panel is held in place by spring clips located on the finish panel.
Position the instrument cluster finish panel, connect the power liftgate switch electrical connector (if equipped) and install the 2 screws.
3. Install the 4 locating tabs on the instrument cluster finish panel reveal into the upper steering column cover.
Edge
4. Position and install the instrument panel center finish panel.
All vehicles
5. Position the lower steering column cover, connect the ambient air temperature sensor hose and electrical connector (if equipped) and install the 2 screws.
6. Connect the battery.
7. NOTE:
- If a new instrument cluster is installed, download the configuration from the scan tool into the new instrument cluster.
- If a new instrument cluster is installed, the instrument cluster and the PCM require a parameter reset to allow the instrument cluster and the PCM to recognize each other. Failure to carry out the parameter reset to the instrument cluster and the PCM may result in a no start condition.
- The vehicles integrated keys (or standard passive anti-theft system [PATS] keys) must be programmed to the new instrument cluster.
Carry out the parameter reset and key programming procedure.
8. Clear all instrument cluster and PCM DTCs.