Steering Column Lock: Service and Repair
Steering Column Lock ModuleSteering Column Lock Module:
1. Depower the supplemental restraints system (SRS). For additional information, refer to Air Bag Systems.
2. NOTE: Release the upper steering column shroud by pressing inward on the sides of the shroud and lifting upwards.
Remove the upper steering column shroud.
3. Release the tilt lever, remove the 3 screws and then remove the lower steering column shroud.
4. NOTE: The top of the instrument panel steering column cover is held in place by tabs that clip to the instrument panel.
Remove the 2 instrument panel steering column cover screws.
^ Detach the instrument panel steering column cover by pulling straight outward.
5. If equipped, disconnect the electrical connector and hose from the temperature sensor.
^ Remove the instrument panel steering column cover.
6. Disconnect the multi-function switch electrical connector.
7. Disconnect the passive anti-theft system (PATS) and ignition switch connectors.
8. NOTE: After cutting slots in the steering lock module bolts, clean all metal shavings and foreign material from the steering column.
Using a suitable tool, cut slots into the heads of the 2 steering lock module bolts.
9. NOTE: The steering lock module bolts are designed to sheer off when tightened.
Remove the 2 steering lock module bolts using a screwdriver.
^ Discard the steering lock module bolts.
^ To install, tighten the steering lock module bolts until the heads of the bolts shear off.
10. Remove the steering lock module clamp and the steering lock module assembly from the steering column.
11. NOTE: Align the locating tab on the steering lock module with the window of the steering column tube. Verify that the lock module operates correctly.
To install, reverse the removal procedure.
12. Repower the SRS. For additional information, refer to Air Bag Systems.