Rear Door Window Regulator: Service and Repair

GLASS, FRAMES AND MECHANISMS - EXPLODED VIEW, REAR DOOR

Part 1:

Part 2:

WINDOW REGULATOR AND MOTOR - REAR DOOR

Removal and Installation

NOTE: LH shown, RH similar.

Window operating/not operating
1. Remove the rear door speaker.

Window not operating

NOTE: Cutting the regulator cable should only be done if installing a new window regulator assembly.







2. NOTE: Support window glass before cutting the window regulator cable.

Cut the window regulator cable.

Window operating
3. Reconnect the window control switch.

Window operating/not operating
4. Remove the access plug and lower the window until the glass clamp bolt can be accessed through the access hole. Tape the glass in position.







5. NOTE: If the window regulator cable was cut previously, support the regulator before the glass clamp bolt is loosened.

Loosen the glass clamp bolt.
- To install, tighten to 9 Nm (80 lb-in).

6. Lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.







7. Disconnect the electrical connector at the B-pillar.







8. Remove the 2 bolts from the electrical harness grommet to the door.
9. Using the speaker hole for access, release the clip on the harness from the inside to disconnect the harness from the door.
10. Unclip the weatherstrip and feed through the wiring harness between the weatherstrip and door.







11. Remove the 3 door latch screws.
- To install, tighten to 12 Nm (9 lb-ft).







12. Remove the access plug from the latch side of the door and remove the outside door handle reinforcement screw.
13. Remove the outside door handle.







14. Remove the screw.
- To install, tighten to 8 Nm (71 lb-in).

15. If equipped, remove the door keypad.







16. Remove the 9 door module bolts and remove the rear door module, transfer parts as necessary.
- To install, tighten to 9 Nm (80 lb-in).

17. To install, reverse the removal procedure.