Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) ModuleMaterial:
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
CAUTION: Electronic modules are sensitive to electrical charges. The ABS module can be damaged if exposed to these charges.
NOTE: When installing a new ABS module it must be configured using the vehicle as-built data and calibrated. For additional information, refer to Information Bus (Module Configuration).
1. Remove the hydraulic control unit (HCU).
2. Remove the 3 anti-lock brake system (ABS) module screws.
^ To install, tighten to 2 Nm (18 inch lbs.)
3. Remove the ABS module.
4. To install, reverse the removal procedure.