Headliner: Service and Repair

HEADLINER







All vehicles
1. Disconnect the battery ground cable and wait at least one minute.







2. Position aside the front and rear door seals.







3. If equipped, remove the roof opening panel trim.
4. Remove the LH and RH A-pillar trim panels.







5. Remove the 2 wiring harness pin-type retainers from the A-pillar.







6. Open and fully lower the glove compartment.
- Release the glove compartment tabs.

7. If equipped, disconnect the satellite radio antenna.







8. Remove the pin-type retainer and disconnect the electronic compass/auto-dimming rearview mirror electrical connector.
9. If equipped, separate the satellite antenna cable from the wiring harness.







10. If equipped, remove the electronic compass sensor.







11. If equipped, disconnect the auto-dimming mirror electrical connector.
12. Remove the LH and RH sun visor clips.
- Remove the 8 screws.
- Remove the sun visors and visor clips.
- If equipped, disconnect the electrical connectors.

13. If equipped, remove the overhead console.
- Disconnect the electrical connectors.

14. If equipped, remove the DVD player.
15. Remove the LH and RH B-pillar trim panels.
16. Remove the LH and RH C-pillar trim panels.
17. Remove the LH and RH D-pillar trim panels.







18. Disconnect the rear electrical connector.

Vehicles with safety canopies
19. Remove the 4 garment hangers.
- Open the access panel.
- Remove the garment hanger screws.

Vehicles without safety canopies







20. CAUTION: To prevent damage to the garment hanger retainer, use a 3/16-inch flat-blade screwdriver for this step.

NOTE: The garment hanger is shown without the roof sheet metal to show the metal retainer clip. The metal retainer clip will remain engaged in the sheet metal after the garment hanger is removed.

Remove the 2 garment hangers.
1 Open the access cover.
2 Insert the flat-blade screwdriver fully into the garment slot.
3 Rotate the screwdriver 90 degrees so that the screwdriver spreads the metal retainer clip. Remove the plastic garment hanger.

All vehicles
21. Remove the center pin-type retainers.
22. Remove the rear pin-type retainers.

Vehicles with rear climate control







23. Tilt the headliner to release the vent duct.

All vehicles
24. Remove the headliner.
25. To install, reverse the removal procedure.
- Transfer parts as necessary.