Power Seat Motor: Service and Repair

POWER-FOLD SEAT MOTOR

Seat Backrest - 40 Percent (Part 1):

Seat Backrest - 40 Percent (Part 2):

Seat Cushion - 40 Percent (Part 1):

Seat Backrest - 60 Percent (Part 1):

Seat Backrest - 60 Percent (Part 2):

Seat Cushion - 60 Percent:

Exploded View

Removal and Installation

NOTE: LH seat shown, RH seat similar.

1. Remove the load floor panel.
2. Remove the 2 bolts and mid-floor panel support.
- Detach the 3 pin-type retainers.

3. Detach the wiring harness pin-type retainer and disconnect the affected power seat motor electrical connector.

4. NOTE: Note position of bushing shoulder for installation.

Remove the bracket-to-pivot bolt and bushing from the power-fold seat motor.
- To install, tighten to 30 Nm (22 lb-ft).

5. Remove the bracket-to-latch bolt and power-fold seat motor.
- Slide the power-fold seat motor and bracket away from the latch and torque shaft.
- For installation, slightly rotate the torque shaft until seated into the power-fold seat motor.

- To install, tighten to 30 Nm (22 lb-ft).

6. To install, reverse the removal procedure.