Seat Cushion Cover - Front, 40 Percent

SEAT CUSHION COVER - FRONT, 40 PERCENT

Seat Backrest - Front, 40 Percent (Part 1):

Seat Backrest - Front, 40 Percent (Part 2):

Seat Cushion - Front, 40 Percent (Part 1):

Seat Cushion - Front, 40 Percent (Part 2):

Seat Cushion - Front, 60 Percent (Part 1):

Seat Cushion - Front, 60 Percent (Part 2):

Exploded View

Removal and Installation

WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the affected seat and depower the supplemental restraint system (SRS).
2. Release the cushion trim cover front and rear J-clips and hook-and-loop strip.







3. NOTE:
- Note wiring harness routing for installation.
- Use care when removing the thermo-electric device (TED). The U-nuts can slip into the cushion frame.

If equipped, remove the climate controlled seat thermo-electric device (TED).
- Disconnect the electrical connector.
- Detach the pin-type retainer and wiring harness.
- Remove the 2 screws.
- Route the wiring harness and remove the TED.

4. Remove the cushion frame from the seat track.
- Remove the 4 cushion frame-to-seat track bolts.
- To install, tighten to 25 Nm (18 lb-ft).

- Release the 2 cushion frame rear clips and straps from the seat track and remove the cushion frame.







5. Release the 2 cushion trim cover retainer clips and remove the trim cover and foam pad from the cushion frame.







6. CAUTION: Use care when separating the cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the cushion foam pad.

Remove the cushion trim cover.
- Partially invert the cushion trim cover to the row of hog rings and separate the hook-and-loop strips.
- Remove the hog rings and separate the trim cover and foam pad.

7. To install, reverse the removal procedure.
8. Install the seat and repower the SRS.