Seat Cushion Thermo-Electric Device

SEAT CUSHION THERMO-ELECTRIC DEVICE

Seat Backrest - Front, 40 Percent (Part 1):

Seat Backrest - Front, 40 Percent (Part 2):

Seat Cushion - Front, 40 Percent (Part 1):

Seat Cushion - Front, 40 Percent (Part 2):

Seat Cushion - Front, 60 Percent (Part 1):

Seat Cushion - Front, 60 Percent (Part 2):

Exploded View

Removal and Installation

WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the affected seat and depower the supplemental restraint system (SRS).







2. NOTE:
- Use care when removing the thermo-electric device (TED). The U-nuts can slip into the cushion frame.
- Note wiring harness routing for installation.

Remove the climate controlled seat thermo-electric device (TED).
- Disconnect the electrical connector.
- Detach the pin-type retainer and wiring harness.
- Remove the 2 screws.
- Route the wiring harness and remove the TED.

3. To install, reverse the removal procedure.
4. Install the seat and repower the SRS.