Seat Position Sensor: Service and Repair

SEAT POSITION SENSOR







Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- Power seat track seat position sensor shown, manual seat track position sensor similar.

1. Raise the driver seat and then position it to the rear of the track.
2. Depower the system.
3. Remove the seat position sensor and bracket bolt.
4. Unhook the seat position sensor and bracket from the seat track cross brace.
5. Disconnect the seat position sensor electrical connector and remove the seat position sensor and bracket.
6. To install, reverse the removal procedure.
7. Repower the system.